LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2011 >> CL600 >> Repair and Diagnosis >> Collision >> General Collision Information >> Rear Wall & Rear End >> Testing & Repair >> Prepare rear crossmember for installation. - AR64.20-P-1100-02SX

Prepare rear crossmember for installation. - AR64.20-P-1100-02SX

Fig 1: Identifying Grinding Surfaces On Rear Crossmember In Cross-Hatched Areas
G07512465Courtesy of MERCEDES-BENZ USA
  1. Grind mating surfaces on rear crossmember (1) down to bare metal in cross-hatched areas with COMMERCIALLY AVAILABLE TOOLS stainless steel round wire brush.

    IMPORTANT Observe preliminary treatment of surfaces to be bonded.

  2. Grind mating surfaces on rear crossmember (1) down to bare metal in cross-hatched areas with COMMERCIALLY AVAILABLE TOOLS stainless steel round wire brush.

    IMPORTANT Observe preliminary treatment of surfaces to be bonded.

    Fig 2: Identifying Rear Crossmember Cross-Hatched Areas
    G07512466Courtesy of MERCEDES-BENZ USA
  3. Grind mating surfaces on rear crossmember (1) down to bare metal in cross-hatched areas with COMMERCIALLY AVAILABLE TOOLS stainless steel round wire brush.

    IMPORTANT Observe preliminary treatment of surfaces to be bonded.

    Fig 3: Identifying Grinding Surfaces On Rear Crossmember
    G07512467Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals