Care for lacquered surfaces - AR98.00-P-0011A

MODEL 164, 166, 197, 170, 171, 172, 203, 204, 207, 209, 211, 212, 215, 216, 218, 219, 220, 221, 230, 240, 251, 463 with scratch-resistant clearcoat system 

1	Wash the vehicle
2	Place polishing sponge exactly in the center on the backup pad	Before commencing the first polishing operation, slightly fog the polishing sponge using deionized water. Polishing machine
3	Apply little polish to the paint or the area to be polished	Shake bottle well before use. Paint finishing system
4	Polish the surfaces designated for treating	Move the polishing machine uniformly, as otherwise irregularities may be visible in the paint reflection. Polish at the rotational lowest speed, approx. 800 rpm (1st stage), for 10 s at moderate pressure in cross-coat action at the damaged area. Then increase rotational speed: 1300 rpm (3rd stage) to 1600 rpm (4th stage). The polishing time at a sanding spot should not exceed 30 s. For larger areas, ensure that a part of the area (approx. 1/4 m2 ) is always completed at a time. Because the polish cracks while polishing, at the start a more abrasive effect is observed, the more intensive gloss only appears at the end. Paint finishing system   Polishing machine
5	Remove any polish residue	Wipe off polish residue using a microfiber cloth dampened with a cleaning solution. Paint cleaner Tack rag	*BR00.45-Z-1016-04A
6	Clean paint surfaces	Fog with demineralized water using a pump-action sprayer and then wipe with a microfiber cloth. Tack rag
7	Seal polishing mark		*BR00.45-Z-1014-04A