Remove/install front bumper - AR88.20-P-2000SCS
MODEL 216 as of model year 2011
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Lift vehicle on lifting platform | ||
| 2 | Remove radiator grille (1) | AR88.40-P-4001SC | |
| 3 | Unscrew bolt (3) | ||
| 4 | Remove cover (5) on left and right | ||
| 5 | Unscrew bolt (6) on left and right | ||
| 6 | Remove fender liner front section from left fender and right fender | ||
| 7 | Unscrew bolt (4) on left and right terminal strip | ||
| 8 | Unscrew nut (7) on left and right | ||
| 9 | Disconnect electrical connectors | ||
| 10 | Remove front bumper (2) | Gap Dimensions on hoods, doors and lids |
AR60.00-P-0700-01SC |
| * BE60.00-P-1001-01T | |||
| * 129589032100 | |||
| 11 | Install in the reverse order |
CHECK VALUES FOR GAPS
| Number | Designation | Model 216 up to model year 2011 | Model 216 as of model year 2011 | |||
|---|---|---|---|---|---|---|
| BE60.00-P-1001-01T | Gap Dimension | Engine hood to fender | Dimension "A" | mm | 3.5 (±0.5) | 3.5 (±0.5) |
| Engine hood to headlamp | Dimension "B" | mm | 3.5 (±0.5) | 3.5 (±0.5) | ||
| Engine hood to A-pillar | Dimension "D" | mm | 4.0 (±0.5) | 4.0 (±0.5) | ||
| Radiator grille/bumper | Dimension "C" | mm | 5.0 (±1.0) | 2.0 (±1.0) | ||
| Engine hood to bumper | Dimension "P" | mm | 5.0 (±1.0) | 5.0 (±1.0) | ||
| Bumper to headlamp | Dimension "Q" | mm | 3.5 (±0.5) | 3.5 (±0.5) | ||
| See picture | AR60.00-P-0700-01SC | AR60.00-P-0700-01SC |