Pull inner bearing race off rear-axle shaft flange - AR35.20-P-0130-02TX

MODEL 172, 204, 207, 211, 212, 216, 218, 219, 231 (except, 216.379) 

MODEL 221 (except 221.179) 

MODEL 221 except CODE (Z07)Top protection 

MODEL 230 except CODE (P99) Special model "AMG Black Series" 

Fig 1: Identifying Puller (001 589 50 33 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Thrust Piece (124 589 02 34 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Chuck (140 589 01 34 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Chuck (211 589 02 34 00)

Courtesy of MERCEDES-BENZ USA

1. Clamp rear axle shaft flange (1) in vise.

   Use protective jaws for vise.

2. Pry protective ring (3) off bearing inner race (2).
3. Mount thrust piece (04) on rear axle shaft flange (1).
   Fig 5: Identifying Protective Ring, Bearing Inner Race, Rear Axle Shaft Flange And Thrust Piece

   Courtesy of MERCEDES-BENZ USA
4. Screw collet (02) onto puller (01) and tighten.

   With model 231 use clamping pliers (02) 140 589 01 34 00.

5. Mount puller (01) onto bearing inner race and clamp securely into place.
6. Screw in thrust spindle (03) and pull bearing inner race off rear axle shaft flange (1) using puller (01).

Fig 6: Identifying Puller And Clamping Pliers

Courtesy of MERCEDES-BENZ USA