Detach, connect front axle electrical distributor connector - AR33.10-P-0100-06CW

MODEL 204, 207, 212, 218 

Shown On Model 204 With Steel Suspension 

Fig 1: Identifying Front Axle Electrical Distributor Connectors

Courtesy of MERCEDES-BENZ USA

1. Press spring latch (3) on front axle electrical distributor downwards and pull left front-axle rpm sensor connector (L6/1) or right front-axle rpm sensor connector (L6/2) and right front brake wear sensor connector (S10/2) out of the front axle electrical distributor.
   NOTE: The right front brake wear sensor connector (S10/2) is only fitted to the front axle electrical distributor on the right side of the vehicle.
   NOTE: For model 212 with code (489) AIRmatic (air suspension with continuous damper adjustment) or code (488) Steel/air suspension and for model 207 with code (483) ADVANCED AGILITY package: The lines for the right front brake wear sensor (S10/2) and the right front axle damping valve unit are combined to form a single line on the right.

   The left front axle damping valve unit line is plugged onto the left front axle electrical distributor connector.

2. Unclip electrical feed lines (1) from line holders (2) and place to one side.