Remove/install pulse ring - AR42.30-P-0715A
Remove rear axle shaft. See REMOVE/INSTALL REAR AXLE SHAFT - AR35.30-P-0620CW .
Clamp rear axle shaft using clamping jaws (220 589 02 31 00) (01) into vise (02).
Remove pulse ring (5) using suitable tool from external joint end (4) of rear axle shaft.
Clean contact surface (4a) of pulse ring (5) on external joint end (4) of rear axle shaft. The contact surface (4a) of the pulse ring 5) on the external joint end (4) must be free of grease and dirt particles. If there is any sign of rust on the contact surface (4a) slightly grind off the contact surface (4a).
To install, mount pulse ring (5) using assembly tool (03) to external joint end (4) of rear axle shaft. The pulse ring (5) must not be knocked on. Otherwise the pulse ring (5) may be irreparably damaged. To install, turn the pulse ring (5) using the assembly tool to block. If necessary, stick pulse ring (5) using adhesive to external joint end (4). Loctite 603 adhesive (BR00.45-Z-1114-02A). Assembly tool (211 589 00 61 00).
Remove rear axle shaft from vise (02) and detach clamping jaws (01). Clamping jaws (220 589 02 31 00).
Install rear axle shaft. See REMOVE/INSTALL REAR AXLE SHAFT - AR35.30-P-0620CW .
Read out fault memory using the diagnostic system and delete if necessary. AD00.00-P-2000-04A.