Adjust tilting/sliding roof panel - AR77.20-P-1100CW
MODEL 204.0/2, 212, 218 with CODE (414) Power glass tilting/sliding roof
Shown on model 204.0
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Move tilting/sliding roof panel (1) into tilt position | ||
| 2 | Completely open sliding roof lining (2) | ||
| 3 | Remove left and right rubber bellows (3) | ||
| Adjust | |||
| 4 | Close tilting/sliding roof panel (1) | ||
| 5 | Loosen bolts (4) on left and right on tilting/sliding roof panel (1) | ||
| 6 | Guide cardboard strips (5) from rear center into sealing joint | The gap dimension should be approx. equal at the front and rear sealing joint. Align side gap dimension in center. |
|
| 7 | Adjust tilting/sliding roof panel (1) in relation to exterior roof surface | *BE77.20-P-1001-01H | |
| 8 | Tighten bolts (4) on left and right on tilting/sliding roof panel (1) from rear toward front | ||
| Install | |||
| 9 | Move tilting/sliding roof panel (1) into tilt position | ||
| 10 | Install left and right rubber bellows (3) | ||
| 11 | Close tilting/sliding roof panel (1) | ||
| 12 | Close sliding roof lining (2) | ||
| 13 | Connect Star Diagnosis and perform teach-in run for anti-pinch protection for tilting/sliding roof | AD00.00-P-2000-04A |
TEST AND ADJUSTMENT VALUES FOR TILTING/SLIDING ROOF
| Number | Designation | Model 204 | Model 212 | Model 218 | ||
|---|---|---|---|---|---|---|
| BE77.20-P-1001-01H | Height setting | Measuring position "A" (x) | mm | 140 | 140 | 140 |
| Front: deeper than outer skin of roof | mm | 0 to 1 | 0 to 1 | 0 to 1 | ||
| Rear: higher than outer skin of roof | mm | 0 to 1 | 0 to 1 | 0 to 1 |