Retrofit cargo retainers - AZ68.50-P-0008CW

MODEL 204.0 except CODE (287) Through-loading feature 

Fig 1: Identifying Cover

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Trunk Floor Paneling, Anchoring Lug, Screw And Cuts

Courtesy of MERCEDES-BENZ USA

	Removing
1	Open trunk lid and remove trunk floor paneling (1).
2	Remove covers (2)
	Install
3	Insert anchoring lugs (3) and tighten bolts (4).	Install each anchoring lug (3) so that the side of the metal bracket bearing is aligned with the center of the trunk. Ensure that the anchoring lugs (3) are seated correctly in the corresponding anti-twist locks (arrows).
		Bolt for anchoring lug	*BA68.50-P-1001-03I
4	Cut trunk floor paneling (1).	Mark the cuts (1a) precisely by holding the trunk floor paneling (1) against the vertical anchoring lugs (3). If applicable, cut trunk floor paneling (1) 55 mm laterally in area of rear anchoring lugs (3). Cut trunk floor paneling (1) 55 mm in longitudinal direction in area of front anchoring lugs (3).
5	Install caps on fastening points on anchoring lugs (3).
6	Insert trunk floor paneling (1).	Pull anchoring lugs (3) through cuts (1a) in trunk floor paneling (1).