Check tires for damage and crack formations - AP40.10-P-4051CW

MODEL 204, 207 

Fig 1: Identifying Shoulder Wear On Front Tire

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Center Wear On Rear Tire

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Interchange Wheel-And-Tire Assemblies (Vehicles Without Mixed Tires)

Courtesy of MERCEDES-BENZ USA

	Checking
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Hoist vehicle with lifting platform until wheels are free
2	Check tires on all wheel-and-tire assemblies	Check tread as well as outer and inner sidewalls on all tires for signs of damage such as cuts, punctures, cracks, breakouts, separation and ingressed foreign matter. If damage is present Replace tire:
		Model 204	AR40.10-P-1030CW
		Model 207	AR40.10-P-1030EW
3	Check tire wear pattern on all wheel-and-tire assemblies	Greater wear at the shoulder compared to the center of the tire is normal for the front wheel-and-tire assemblies. On the tires of the rear wheel-and-tire assemblies the wear at the center of the tread depth is mostly somewhat more pronounced than at the tire shoulders. In the case of an unusual wear pattern, determine and eliminate the cause for the increased tire wear, then:	Replace tire:
		Model 204	AR40.10-P-1030CW
		Model 207	AR40.10-P-1030EW
	Measure
4	Measure depth of tread of all tires and note measured values on the maintenance sheet	The main tread along the entire circumference must have a tread depth of at least 1.6 mm. Measure depth of tread at point of greatest wear. Perform measurement at outside, inside and center of main tread. The wide tread grooves in the center area of the tread, which accounts for roughly 3/4 of the tread width is deemed to be the main tread. For safety reasons tires should be replaced before reaching the minimum tread depth: Summer tires for approx. 2 to 3 mm depth of tread Winter tires at approx. 4 mm tread depth
	Notes on measuring tire tread depth		AH40.10-P-0006-01T
			*211589062300
5	Interchange wheel-and-tire assemblies on front and rear axles	If necessary, and only on vehicles without mixed tires Maintain running direction of wheel-and-tire assemblies. Otherwise handling characteristics and handling comfort may be impaired and tire wear increased. Depending on the state of wear after a distance between 5000 and 10, 000 km.	AP40.10-P-4050CW
6	Lower vehicle

Fig 4: Identifying Brake Pad Check Gauge (211 589 06 23 00)

Courtesy of MERCEDES-BENZ USA