Remove/install rear seat backrest side bolster (MODEL 204.0, 212.0, 218.3 with CODE (287) Through-loading feature) - AR91.12-P-1710CW

MODEL 204.0, 212.0, 218.3 with CODE (287) Through-loading feature

Shown on model 204.0

Fig 1: Identifying Side Bolster, Seat Belt, Screw, Guide Sleeve And Clip

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove rear seat cushion	Model 204 Model 212 except code (224) Design rear bucket seats	AR91.12-P-1020CW
1	Remove rear seat cushion	Model 218.3	AR91.12-P-1020EL
2	Unscrew bolt (3)
3	Pull seat belt (2) to one side
4	Pull side bolster (1) at top out of guide sleeve (4) and remove from vehicle	Make sure that the wire clip of the side bolster (1) is engaged into the clip (5) on the wheel arch.
5	Install in the reverse order