Remove/install overhead control panel control unit - AR82.20-P-1000CW
WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 204
Shown on model 204.0
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Perform initial startup of overhead control panel control unit (N70) or overhead control panel electronics (N70/3) with Star Diagnosis | When replacing overhead control panel control unit (N70) with code (414) Power glass tilting/sliding roof or with code (965) Electrical preinstallation for rental vehicles. |
AD00.00-P-2000-04A |
| 2 | Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit | ||
| 3.1 | Unclip mirror base cover (1) | Model 204, 207.3, 212, 218 | |
| *115589035900 | |||
| 4 | Use a check card (2) or similar object to release the lock (3) and fold down overhead control panel control unit (N70) or electronic overhead control panel (N70/3) at rear and unhook at front (arrows) | ||
| 5 | Detach all electrical connectors on the overhead control panel control unit (N70) or electronic overhead control panel (N70/3) | ||
| 6 | Install in the reverse order | ||
| 7 | Normalize tilting/sliding roof | When replacing overhead control panel control unit (N70) with code (414) Power glass titling/sliding roof. |