Adjust front panoramic glass roof - AR77.21-P-0501CW
WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 204.0 /2 /9 with CODE (413) Panoramic sliding roof
MODEL 246 with CODE (413) Panoramic glass roof with top sliding roof
Shown on left side of front glass roof on model 204.0
| Removing | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Move front glass roof (1) to tilt position | ||
| 2 | Remove left and right cover (2) | ||
| 3 | Loosen seal (3) in area of bolts (4) | ||
| 4 | Loosen bolts (4); do not remove completely | ||
| 5 | Close front glass roof (1). | ||
| Adjust | |||
| 6 | Adjust front glass roof (1). | Observe measuring position (A) for height adjustment |
|
| Height setting | *BE77.21-P-1001-01E | ||
| 7 | Tighten bolts (4) | ||
| Install | |||
| 8 | Move front glass roof (1) to tilt position | ||
| 9 | Fasten seal (3) | ||
| 10 | Install left and right cover (2) | ||
| 11 | Synchronize panoramic roof and perform teach-in run for anti-pinch protection | AD00.00-P-2000-04A |
TEST AND ADJUSTMENT VALUES OF PANORAMIC ROOF
| Number | Designation | Model 204 | Model 246 | ||
|---|---|---|---|---|---|
| BE77.21-P-1001-01E | Height setting | Measuring position "A" (X) | mm | 140 | 140 |
| Front: deeper than outer skin of roof | mm | 0 to 1 | 0 to 1 | ||
| Rear: higher than outer skin of roof | mm | 0 to 1 | 0 to 1 | ||