Remove/install the tumble flap position sensor at intake manifold - AR09.20-P-1995CV
ENGINE 272 (except 272.982) in MODEL 204
ENGINE 272, 273 (except 272.984) in MODEL 207
| Remove/install | |||
| 1 | Remove air filter housing | AR09.10-P-1150CV | |
| 2 | Disconnect electrical connector (1) on position sensor (B28/9 or B28/10) | ||
| 3 | Remove bolt (2) and take position sensor (B28/9 or B28/10) out of the resonance intake pipe (3) | *BA09.20-P-1002-01N | |
| 4 | Install in the reverse order |
INTAKE MANIFOLD
| Number | Designation | Engine 272 | Engine 273 | |
|---|---|---|---|---|
| BA09.20-P-1002-01N | Bolt, tumble flap position sensor to resonance Nm intake manifold | Nm | 6 | 6 |