Remove/install telescoping nozzle for headlamp cleaning system - AR82.15-P-6100CW

MODEL 204.0 /2, 207, 212 with CODE (600) Headlamp cleaning system 

Shown on model 204 at right side of vehicle 

Fig 1: Identifying Headlamp Cleaning System Removing/Installing Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Lift vehicle on lifting platform.
2.1	Unfasten washer fluid reservoir of windshield washer system and push to side with lines connected	When removing left telescopic nozzle (1).	AR82.35-P-6000CW
2.2	Detach front section of fender liner in right front fender far enough until the telescopic nozzle (1) can be removed	Except model 212.077/277, when removing right telescopic nozzle (1).
2.3	Remove front bumper	Model 212.077/277, when removing right telescopic nozzle (1).	AR88.20-P-2000EW
3	Unclip air filter of stationary heater unit and push to one side	Model 212 with code (228) Stationary heater, when removing right telescopic nozzle (1).
4	Disconnect washing water hose (6) with clamp		Fig 2
5	Detach hose coupling (7) with washer fluid hose (6) from telescopic nozzle (1)
6	Open flap of headlamp cleaning system in front bumper
7	Unscrew bolt (2)	The screw (2) remains in the left front lamp unit (E1) or right front lamp unit (E2).
8	Release catch hook (3) and slide left and right telescopic nozzles (1) to the rear
9	Remove telescopic nozzle (1)	Installation:  Check that journals (4, 5) on telescopic nozzle (1) are correctly seated in guides on left front lamp unit (E1) or right front lamp unit (E2).
10	Install in the reverse order
11	Check spray nozzle setting of headlamp cleaning system, adjust if necessary	Model 204	AP82.30-P-8252CW
		Model 207, 212	AP82.30-P-8252EW

Fig 2: Identifying Clamping Device (000 589 40 37 00)

Courtesy of MERCEDES-BENZ USA