Retrofit rear entertainment wiring harness - AZ82.60-P-0015-02CWA

Routing diagram 

Fig 1: Identifying Retrofit Rear Entertainment Wiring Harness Routing Diagram

Courtesy of MERCEDES-BENZ USA

Connection scheme 

Fig 2: Identifying Retrofit Rear Entertainment Wiring Harness Connection Diagram

Courtesy of MERCEDES-BENZ USA

Make sure that the wiring harnesses are not damaged by chafing, pinching or crushing, as otherwise the corresponding wiring harness may have to be replaced.

1. Route wiring harness (6) from previously created opening in seat to video control unit (1).

   The video control unit (1) is only placed in the seat and is installed at a later point.

2. Connect wiring harness (6) to video control unit (1).

   The white 12-pin coupling (23) is connected at a later point.

3. Fasten wiring harness (6) at seat frame using cable ties.
4. Strap down excess length of line.
   Fig 3: Identifying 12-Pin Coupling Routing Diagram

   Courtesy of MERCEDES-BENZ USA
5. Route wiring harness (9) from video control unit (1) to left front seat connector block.

   The video control unit (1) is only placed in the seat and is installed at a later point.

6. Connect wiring harness (9) to video control unit (1).
7. Fasten wiring harness (9) at seat frame using cable ties.

   Take care that the adjustment mechanism of the seat is not impaired by the installation of lines, as this may lead to shearing or crushing of the wiring harness (9).

   Fig 4: Identifying Video Control Unit And Wiring Harness

   Courtesy of MERCEDES-BENZ USA
8. Detach and disconnect left front seat connector block (X55/3).
9. Connect black 2-pin coupling (24) and black 2-pin connector (25) with disconnected left front seat connector block (X55/3).

   The black 2-pin coupling (24) and the black 2-pin connector (25) are coded and cannot be swapped.

   Fig 5: Identifying Front Seat Connector Block And Black 2-Pin Coupling

   Courtesy of MERCEDES-BENZ USA
10. Connect assembled connectors and fuse carrier at the carrier (33).
11. Fix wiring harness in place with cable ties.
    Fig 6: Identifying Fuse Carrier

    Courtesy of MERCEDES-BENZ USA
12. Connect wiring harness (7) to video control unit (1) and route to previously created opening in backrest on passenger side.

    To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats.

13. Connect wiring harness (7) with right screen wiring harness (8) and fasten right screen wiring harness (8) with cable ties.
    Fig 7: Identifying Video Control Unit And Wiring Harness

    Courtesy of MERCEDES-BENZ USA