LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2010 >> SLK55 >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Axle - 171 Chassis >> Testing & Repair >> Remove/install rear axle differential - AR35.31-P-0520V >> Check rear axle center assembly oil level, top up if necessary - AR35.31-P-0520-03V

Check rear axle center assembly oil level, top up if necessary - AR35.31-P-0520-03V

REAR AXLE CENTER ASSEMBLY HOUSING

Number Designation Model 171 except model 171.473 Model 171.473
BA35.31-P-1002-02C Oil filler plug, rear axle center assembly Nm 50 50
REAR FINAL-DRIVE UNIT

Number Designation Model 171.442/454 Model 171.456 Model 171.473
BF35.31-P-1001-01O Filling capacity Rear axle center assembly Liters 1.0 1.1 1.2
- - - - -
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1061-01A Sealant, Omnifit 100H (50 g) A 002 989 23 71
BR00.45-Z-1046-04A Cleaning spray, Loctite 7063 (150ml) A 001 986 71 71 10
Fig 1: Identifying Oil Filler Plug
G05027468Courtesy of MERCEDES-BENZ USA
  1. Clean area around oil filler plug (50g).
  2. Unscrew oil filler plug (50g)

    IMPORTANT If necessary collect oil running out and allow to run out until oil only drips out of opening.

    IMPORTANTInstallation:  Replace oil filler screw (50g).

  3. Check oil level.

    IMPORTANT Check oil level only at room temperature and not when rear axle center assembly is warm. Oil which is otherwise needed might flow out when the rear axle center assembly is hot.

    IMPORTANT The rear axle is correctly filled when the oil reaches the bottom edge of the oil filler hole. If necessary refill with hypoid gear oil.

    IMPORTANT The fully synthetic oil can also be used without reservation for rear axle gears manufactured before 4.11.2001. Mixing old universal hypoid gear oil and new FE hypoid gear oil does not impair the base functions such as wear characteristics, leaktightness, etc. at the rear axle gear, but should however be avoided in order to achieve a better fuel economy behavior.

  4. Clean new oil filler screw (50g) and tapped hole in rear axle center assembly using Loctite 7063 cleaning spray.

    IMPORTANT Oil filler screw (50g) and tapped hole have to be free of oil and grease.

  5. Apply about one droplet of Omnifit 100H sealing compound on the second or third lower thread.
  6. Screw oil filler screw (50g) into rear axle center assembly immediately and tighten TORQUE SPECIFICATION .
    Fig 2: Applying Droplet Of Omnifit Sealing Compound On Second Or Third Lower Thread
    G05027469Courtesy of MERCEDES-BENZ USA