Remove/install cigarette lighter - AR54.10-P-0030TX
MODEL 171
Shown on model 219
| Remove/install | |||
| 1 | Switch off the ignition and remove the KEYLESS transmitter key from the EIS control unit | On vehicles with code (889) KEYLESS-GO: Press keyless go start/stop button repeatedly until ignition is switched off. Remove KEYLESS-GO chip card or transmitter key from the vehicle and store outside the transmitter range (at least 2 m). | |
| 2.1 | Open ashtray | except model 204, 207, 212 | |
| 2.2 | Remove ashtray housing (5) | MODEL 212 without CODE 279(Electronic gear selector) MODEL 204.0/2/3, 207 MODEL 204.9 up to model year 2013 | |
| 3 | Pull insert (1) out of the housing (3) of the cigarette lighter with front ashtray illumination (R3) | ||
| 4 | Insert pliers (2) into the housing (3) and pull the housing (3) out of the clamping sleeve (4) | The spigots of the pliers (2) must engage in the cutouts of the housing (3) (arrows A). | Pliers 169589003700 |
| 5 | Disconnect electrical connector of cigarette lighter with front ashtray illumination (R3x1) | except model 204, 207, 212 | |
| 6 | Unclip spring sleeve (4) from ashtray housing 5) by pressing back catch hooks (arrows B), | Installation: Check for correct installation position of spring pin (4). | |
| 7 | Install in the reverse order |