Remove/install paneling on rear center section - AR68.30-P-4785R

MODEL 230.4 except CODE (P99) "AMG Black Series" special model 

Fig 1: Identifying Paneling On Rear Center Section Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Open trunk lid
2	Take floor covering (2) out of luggage compartment
3	Remove expansion clips (3)	Installation:  Replace damaged expansion clips (3).
4	Remove screw clips (3).	Installation:  Replace damaged screw clips (4).
5	Loosen rear center section paneling (1) from rear center section until electrical connectors on luggage compartment lamp (E18/1) and interior socket (X58/1) are accessible.	Lift rear center section paneling (1) over locking eye cover.
6	Disconnect electrical connectors from luggage compartment lamp (E18/1) and interior socket (X58/1)	Insulate socket with insulation tape to prevent short circuit
7	Remove paneling from rear center section (1)
8	Install in the reverse order