Adjust rear-axle toe - AR40.20-P-0261R
MODEL 230.4
MODIFICATION NOTES
| 17.7.07 | Overall toe-in at rear axle | *BE40.20-P-1001-10D | |
| Permitted difference between right and left side of vehicle for rear-axle toe. | *BE40.20-P-1002-10D |
| Adjust | |||
|---|---|---|---|
| 1 | Use brake piston insertion tool (086) to pull rear exhaust system (100) downward at the cross strut (101) | Fig 2 | |
| 2 | Loosen bolt (60b) and bolt (60c) | Fig 3 | |
| 3 | Adjust toe with the adjusting nut (60d) | Overall toe-in at rear axle | *BE40.20-P-1001-10D |
| Permitted difference between right and left side of vehicle for rear-axle toe | *BE40.20-P-1002-10D | ||
| Remove/install track rod | AR35.20-P-0109R | ||
| 4 | Tighten bolt (60b) and bolt (60c) | *BA35.20-P-1002-04C | |
| Fig 3 | |||
| 5 | Remove insertion tool for brake piston (086) | Fig 2 |
INSPECTION VALUES FOR TOE-IN AT REAR AXLE
| Number | Designation | Model 230 | |
|---|---|---|---|
| BE40.20-P-1001-10D | Overall toe-in at rear axle | ∠° | 0° 12'(± 7') |
| BE40.20-P-1002-10D | Permissible difference in rear axle toe between right and left sides of the vehicle | ∠° | 7' |
TIE ROD
| Number | Designation | Model 230.467/ 474/475/ 476/479 | |
|---|---|---|---|
| BA35.20-P-1002-04C | Self-locking nut, tie rod to rear axle carrier | Nm | 70 |