Notes on application of sealant to oil pan - AH01.45-P-0001-01SX

MODIFICATION NOTES

28.2.06

Sealant path for adapted to specifications of the Development Department

Engine 273

Oil pan with front sump

The line (A) identifies the sealant run.

The sealing surface must be cleaned. The sealant must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm). The sealant must be applied within 10 min. The sealant bead must not be spread. Only the sealant listed in the Repair Products may be used.

Fig 1: Identifying Sealant Application Areas On Oil Pan With Front Sump

Courtesy of MERCEDES-BENZ USA

Oil pan with rear sump

Fig 2: Identifying Sealant Application Areas On Oil Pan With Rear Sump

Courtesy of MERCEDES-BENZ USA

Oil pan with middle sump

Fig 3: Identifying Sealant Application Areas On Oil Pan With Middle Sump

Courtesy of MERCEDES-BENZ USA