Removing and installing loudspeaker in instrument panel - AR82.62-P-7833GZ

MODEL 164 with CODE (810) Sound system 

Shown on vehicles with Parktronic system (PTS), code 220 

Fig 1: Identifying Instrument Panel Loudspeaker Components Location

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Switch off ignition and remove the transmitter key from the EIS [EZS] control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2	Carefully unlatch center cockpit speaker (centerfill) cover (1) at rear edge (arrow) and pull upward out of installation opening	Protect instrument panel from being scratched. Installation:  Insert center cockpit speaker (centerfill) cover with the two front lugs first, then latch in at the rear at the clamp.
		Long wedge	Figure
3	Separate electrical connectors (2)
4	Undo screws (3) and remove center cockpit speaker (centerfill) (H4/27)
5	Install in the reverse order

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.