Remove/install contact plate for cell phone holder (UPCI (UHI)) in the armrest - AR82.70-P-8919EW

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 212.0/1 with CODE 279 (Electronic gear selector) with CODE 386 (Comfort telephony)

MODEL 218 with CODE 386 (Comfort telephony)

Shown on model 212.0

Fig 1: Cell Phone Holder Contact Plate Remove/Install Components - Shown On Model 212.0

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1.1	Remove rear air vent (6) from center console (2) and lay down to one side with electrical lines connected	MODEL 212.0/1 with CODE 279 (Electronic gear selector) with CODE 386 (Comfort telephony) MODEL 218.9 with CODE 386 (Comfort telephony)
		MODEL 212.0/1 with CODE 279 (Electronic gear selector) with CODE 386 (Comfort telephony)	AR83.10-P-4800CW
		MODEL 218.9 with CODE 386 (Comfort telephony)	AR83.10-P-4800EL
1.2	Remove rear center console and place to one side with connected electrical lines	MODEL 218.3 with CODE 386 (Comfort telephony)
			AR68.20-P-2020EL
2	Remove stowage compartment (5) from center console (2) and lay down to one side with electrical lines connected	MODEL 212.0/1 with CODE 279 (Electronic gear selector) with CODE 386 (Comfort telephony) MODEL 218.9 with CODE 386 (Comfort telephony)
		MODEL 212.0/1 with CODE 279 (Electronic gear selector) with CODE 386 (Comfort telephony)	AR68.20-P-2230EW
3	Fold cover (7) up toward rear	MODEL 212.0/1 with CODE 279 (Electronic gear selector) with CODE 386 (Comfort telephony)
4	Slide back foam rubber jacketing and disconnect mobile phone electrical connector (X39/37)
5	Unscrew bolt (3)	MODEL 212.0/1 with CODE 279 (Electronic gear selector) with CODE 386 (Comfort telephony)
6	Remove bracket (1) from center console (2)
7	Unscrew screw (arrow)
8	Remove cover (4) with Bluetooth module (A34/7) upwards out of center console (2) while leading electrical wiring harness of Bluetooth module (A34/7) out of center console (2)
9	Unscrew screw/bolt (8) and remove Bluetooth module (A34/7) with electrical wiring harness from cover (4)
10	Install in the reverse order