LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2010 >> GLK350 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Brakes - Hydraulic & Mechanical System - Maintenance - 1 Of 2) >> Maintenance >> Replace Brake Fluid >> Replace brake fluid - AP42.00-P-4280RQ

Replace brake fluid - AP42.00-P-4280RQ

WARNING: This page does not describe the selected car, but rather 203 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 197.3/4 

MODIFICATION NOTES

17.11.14 Bleed screw to brake caliper MODEL 197 with CODE B07 BA42.10-P-1003-10T
Fig 1: Identifying Filling And Bleeding Device, Cap & Brake Fluid Reservoir
G10037974Courtesy of MERCEDES-BENZ USA
DANGER Risk of accident  when commissioning the vehicle due to a lack of braking effect when the service brake is operated for the first time after repair work. Before starting the engine, actuate brake pedal several times until pressure is built up and maintained in the brake system. AS42.50-Z-0002-01A
DANGER Risk of poisoning  from swallowing brake fluid. Risk of injury  from skin and eye contact with brake fluid Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. AS42.50-Z-0001-01A
DANGER Risk of injury  . Skin or eye injuries may result when handling hot or glowing objects. Wear protective gloves, protective clothing and safety glasses, if necessary. AS00.00-Z-0002-01A
NOTES Notes on handling, transport and storage of ceramic brake disks   AH42.10-P-9406-13A
NOTES Notes on repairs to brake system   AH42.00-P-0003-01A
NOTES Brake fluid notes   AH42.50-P-0001-01A
  Preparatory activity     
1 Remove covering on brake unit MODEL 197.3/4
with CODE B14 (Carbon-fiber engine compartment cover)
 
CLEANING Clean     
2 Clean cap (1) and brake fluid reservoir (2)    
REMOVING Remove     
3 Unscrew cap (1)    
4 Suction off brake fluid from the brake fluid reservoir (2)    
5 Fill brake fluid reservoir (2) with new brake fluid up to Max. mark    
6 Connect filling and bleeding unit (01) onto brake fluid reservoir (2) and switch on IMPORTANT Observe the operator's manual for the filling and bleeding unit (01).  
  Change fluid     
7 Lift vehicle on vehicle lift    
REFER TO TESTING & REPAIR AR00.60-P-1000RQ
8 Replace brake fluid    
REFER TO CAPACITIES & SPECIFICATIONS General brake fluid DOT 4. See GENERAL BRAKE FLUID (https://bevo.mercedes-benz.com/index.php?language_id=1)
REFER TO CAPACITIES & SPECIFICATIONS Brake fluids (DOT 4 plus) MB 331.0 brake fluid A 000 989 08 07
TORQUE SPECIFICATION Bleed screw on front axle brake caliper *BA42.10-P-1003-10T 
TORQUE SPECIFICATION Bleed screw on rear axle brake caliper
New brake fluid must escape without any bubbles via the bleed hose:
↓
Bleed the system.
*BA42.10-P-1003-12T 
REFER TO TESTING & REPAIR AR42.10-P-0010-02RQ
INSPECT Check     
9 Check brake system for leaks    
REFER TO TESTING & REPAIR AR42.10-P-0100-01RQ
If there are problems:
↓
Rectify problem subject to separate repair order.
INSTALLING Install     
10 Lower vehicle with lifting platform    
11 Disconnect filling and bleeding unit (01)    
12 Screw on cap (1)    
INSPECT Check     
13 Check fluid level in brake fluid reservoir (2)   AP42.10-P-4210RQ 
FRONT AXLE BRAKE CALIPER

Number Designation MODEL 197 except CODE B07 MODEL 197 with CODE B07
BA42.10-P-1003-10T Bleed screw to brake caliper Nm 18 18
REAR AXLE BRAKE CALIPER

Number Designation MODEL 197
BA42.10-P-1003-12T Bleed screw to brake caliper Nm 18