Install and weld in outer rear center section - AR64.20-P-1000-10GY
| Measures for preventing damage to vehicles or components when performing electric welding work | All models | AH00.00-N-0005-01A |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1003-02A | Clamping pliers |
| WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm |
WORKSHOP EQUIPMENT
| WE58.40-Z-1002-02A | Spot welder |
| WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
| WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
- Fit outer rear center section and fasten with clamping pliers
.
If applicable, realign outer rear center section in relation to adjacent surfaces.
outer rear center section in areas A and B.
- Clean weld joints.