Retrofit illuminated door sill molding - AZ82.20-P-0001AMM

MODEL 164.1## 1#

Installation of door sill molding (2-fold) with "AMG" lettering

Fig 1: Identifying Illuminated Door Sill Moldings (Front Left And Right)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

MODIFICATION NOTES

26.7.06

"Disconnect/connect battery ground line" removed

Step 1

	Removal
	Risk of death caused by contact with parts conducting high voltages.	Do not come into contact with parts that are under high voltage. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out any work on such components.	AS00.00-Z-0020-01A
1	Remove side paneling in trunk	Right side only.
			AR68.30-P-4800GZ
2	Remove paneling on left and right B-pillar	Do not unscrew seat belt.
			AR68.30-P-4700GZ
3	Remove rear fuse and relay box	Do not disconnect electrical connectors.
			AR54.15-P-1261GZ
4			Tilt back rear bench seat
5	Remove cover from floor below rear bench seat
	Install
6	Retrofit wiring harness.	Route wiring harness for illuminated door sill molding and connect	AZ82.70-P-0001-04AMM
7	Carry out function check
8	Assemble in the reverse order	Operation steps 6 to 1. When installing the door sill moldings, please ensure that the door sill moldings are not installed at the wrong sides and that the wiring harness is not pinched by the door sill molding.

PARTS ORDERING NOTES

Part no.	Designation	Quantity
B6 602 10 29	Illuminated door sill moldings with cable set, black (2-fold with "AMG" lettering)	as required
B6 602 10 30	Illuminated door sill moldings with cable set, buckskin (2-fold with "AMG" lettering)	as required
B6 602 10 31	Illuminated door sill moldings with cable set, alpaca gray (2-fold with "AMG" lettering)	as required