Separate outer rear center section - AR64.20-P-1000-01GY

Fig 1: Identifying Spot Weld Milling Cutter (201 589 00 51 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1002-01A	Ball cutter, dia. 12 mm
WH58.30-Z-1006-01A	Vario Drill WS 91 spot weld removing tool
WH58.30-Z-1001-03A	Round wire brush, braided, dia. 70 mm
WH58.30-Z-1022-04A	Cutting disk, dia. 50 mm, 80 m/s (max. 30,600 rpm)

WORKSHOP EQUIPMENT

WE58.40-Z-1001-03A	Drill (electric/pneumatic)
WE58.40-Z-1002-03A	Straight grinder (electric/pneumatic)

1. Expose spot welds in areas A and B and cut out .

   Use ball cutter in area B.

2. Remove outer rear center section.
   Fig 2: Identifying Outer Rear Center Section Spot Welds Areas A And B

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.