Install Celette module members - AR60.10-P-1060-01GZ
COMMERCIALLY AVAILABLE TOOLS
| Number |
Designation |
| WH58.30-Z-1007-06A |
Reversible ratchet |
| WH58.30-Z-1026-06A |
Screwdriver bit, 8 mm for hexagon socket head screws |
| WH58.30-Z-1002-11A |
Double end box wrench, offset, 22 x 24 mm |
WORKSHOP EQUIPMENT
| WE58.40-Z-1001-01E |
Celette straightening bench |
| WE58.40-Z-1007-01E |
Celette module crossmember set 955.940 |
| WE58.40-Z-1008-01E |
Celette additional member 955.908 |
| WE58.40-Z-1008-03A |
Pneumatic ratchet |
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
The figure shows the basic setup of the Celette straightening bench. If straightening and welding operations are to be performed on A, B, C or D-pillars, additional modules must be installed on the Celette straightening bench. Refer to the Celette setup plans and separate work instructions.
The modular longitudinal members (A1, B1), the module members (C) and the auxiliary member module (D) can be used on any Celette straightening bench approved by Mercedes-Benz.
- Place modular longitudinal members (A1, B1) onto basic carrier, align parallel to one another and install.
The modular longitudinal members (A1, B1) are aligned parallel to one another with the assembly strips provided with the straightening bench.
- Install module members (C) in index fields 14, 27, 30, 36 and 41.
The basic carrier of the Celette straightening bench is subdivided into index fields in the longitudinal direction. The index fields are marked with numbers at the side straightening bench flange.
- Install auxiliary member module (D) in index field 24.
The basic carrier of the Celette straightening bench is subdivided into index fields in the longitudinal direction. The index fields are marked with numbers at the side straightening bench flange.