Balancing wheels - AR40.10-P-1040GZ

MODEL 164

Fig 1: Balancing Wheels

G10116530

Courtesy of MERCEDES-BENZ USA

	Balancing
	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Information on tires/rims		AH40.10-P-9411-01A
1	Remove balance weight with retaining clamp (43a)	If there are several balance weights with retaining clamp, all of them should be removed.
1	Remove balance weight with retaining clamp (43a)	Mounting tool	Figure
2	Remove self-adhesive balance weight (43b, 43c)	If there are several self-adhesive balance weights, all of them should be removed.
2	Remove self-adhesive balance weight (43b, 43c)	Mounting tool	Figure
3.1	Clean disk wheel	If necessary.
4.1	Mounting centering sleeve	When the centering sleeve is not already mounted.	AR40.10-P-1040-01A
		Centering sleeve DUO-FLEX 2	*WH58.30-Z-1002-18A
		Conversion kit	*WH58.30-Z-1003-18A
5	Fasten disk wheel on steady-state balancing machine	Observe information provided by balancing machine manufacturer.
6	Balance disk wheel	Observe information provided by balancing machine manufacturer. The disk wheel may only feature a maximum of 5 g residual imbalance.
7	Detach disk wheel from the steady-state balancing machine
8.1	Balance the other disk wheels as per the same procedure	If necessary.

Fig 2: Identifying Assembly Tool (124 589 17 63 00)

G07472757

Courtesy of MERCEDES-BENZ USA

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1002-18A	Centering sleeve
WH58.30-Z-1003-18A	Conversion kit