Remove/install water drain channel on tilting/sliding roof - AR77.20-P-1999TX
MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof
| Remove/Install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Completely open sliding roof lining (2) | ||
| 2 | Open tilting/sliding roof cover (4) approx. 20 cm | ||
| 3 | Unclip covering (3) in center and on side with mounting wedge (6), move covering (3) out of rubber bellows (5) | Figure | |
| 4 | Completely close tilting/sliding roof cover (4) and then move tilting/sliding roof (4) to pop-up position | ||
| 5 | Remove left and right rubber bellows (5) from tilting/sliding roof cover (4) | ||
| 6 | Unclip water drain channel (1) from left and right brackets on pop-up bracket (8) with long wedge (7) | Figure | |
| 7 | Slide water drain channel (1) on passenger side in between sliding sunroof lining (2) and roof paneling, pull out on driver's side and remove. | ||
| 8 | Install in the reverse order | ||
| 9 | Perform teach-in run for tilting/sliding roof obstruction sensor | ||
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| Diagnosis system STAR DIAGNOSIS | *WH58.30-Z-1048-13A |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation | |
|---|---|---|
| WH58.30-Z-1048-13A | STAR DIAGNOSIS, diagnosis system; Compact Passenger Car | 6511 1801 00 |