Remove/install tilting/sliding roof frame - AR77.20-P-3000TX

MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof 

Fig 1: Identifying Tilting/Sliding Roof Frame Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Tilting/Sliding Roof Frame Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1.1	Remove tilting/sliding roof paneling	Only when replacing tilting/sliding roof frame (1).	AR77.20-P-0500TX
2.1	Remove tilting/sliding roof liner (2)	Only when replacing tilting/sliding roof frame (1).	AR77.20-P-1000TX
3	Remove paneling from both upper A-pillars		AR68.30-P-4050TX
4	Remove paneling from both B-pillars		AR68.30-P-4700TX
5	Remove paneling from both C-pillars		AR68.30-P-4490TX
6	Move backrests of both front seats to inclined position	See Operating Instructions
7	Lay protective covers on center console at front and rear
8	Remove headliner	Do not remove windshield. Lay headliner as far as possible in rear of vehicle with electric wiring harnesses connected	AR68.30-P-4300TY
9	Remove water drain hoses (3) from corners on tilting/sliding roof frame (1)	Do not damage water drain hoses (3). Otherwise water can leak in and cause damage
10	Insert assembly pliers (4) into tilting/sliding roof frame (1)		Fig 3
11	Unscrew bolts (5)		*BA77.20-P-1003-01F
		Rechargeable battery-powered drill/screwdriver	*WH58.30-Z-1007-20A
12	Unscrew nuts (6)		*BA77.20-P-1005-01F
		Rechargeable battery-powered drill/screwdriver	*WH58.30-Z-1007-20A
13	Remove both assembly pliers (4) simultaneously and remove tilting/sliding roof frame (1) from vehicle	Remove both assembly pliers (4) simultaneously to prevent damage to tilting/sliding roof frame (1) Helper required
14	Install in the reverse order	When replacing tilting/sliding roof frames (1) use new seal (7) and transfer SR motor (M12m1)

Fig 3: Identifying Assembly Pliers (202 589 01 37 00)

Courtesy of MERCEDES-BENZ USA