Remove/install track rod - AR46.40-P-0200TX

MODEL 219 

Fig 1: Identifying Track Rod Remove/Install Components

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

15.6.10

Value modified: Self-locking nut, tie rod to steering knuckle, Stage 2

*BA46.40-P-1001-01E

	Remove/install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Remove front wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050TX
2	Pry off tie rod joint (10a) from steering knuckle assembly.	Replace self-locking nut.	AR46.40-P-0200-02TX
			*BA46.40-P-1001-01E
			Fig 3
			Figure
3	Release locknut (10f) and undo tie rod (10)	Counter the tie rod to slacken the locknut (arrows).
			*BA46.40-P-1002-01E
4	Install in the reverse order
5	Perform chassis alignment		AR40.20-P-0200TX

TIE ROD

Number	Designation			Model 219
BA46.40-P-1001-01E	Self-locking nut, tie rod to steering knuckle	Stage 1	Nm	50
		Stage 2	∠°	90
BA46.40-P-1002-01E	Lock nut, tie rod to inner tie rod		Nm	60

Fig 2: Identifying Thrust Piece (140 589 00 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Puller (140 589 00 33 00)

Courtesy of MERCEDES-BENZ USA