Remove/install bulb for ashtray illumination - AR82.20-P-0130TX

MODELS 219.3 

Fig 1: Identifying Ashtray Illumination Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1.1	Switch off the ignition and remove the transmitter key from the EIS control unit	On vehicles without code (889) Keyless Go
1.2	Switch off ignition and store transmitter key beyond its range	On vehicles with code (889) Keyless Go
2	Open ashtray
3	Pull insert (1) out of housing (3) of illuminated cigar lighter (R3)
4	Insert pliers (2) into the housing (3) and pull the housing (3) out of the roll pin with illumination (4)	The jaws of the pliers (2) have to engage into the cutouts of the housing (3) (arrow A).
			Fig 2
5	Unclip roll pin with illumination (4) from the ashtray housing (5) by pushing back the catch hooks (arrows B) and remove	The bulb for the ashtray illumination is integrated in the housing (3) of the illuminated cigar lighter (R3) and can not be exchanged separately.
6	Install in the reverse order

Fig 2: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA