Remove/install additional washer fluid reservoir of windshield washer system - AR82.35-P-6001TX

MODEL 219.3 

Fig 1: Identifying Washer Fluid Reservoir Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Open engine hood and raise to vertical position		AR88.40-P-1000TX
2	Remove housing from combination filter		AR83.00-P-1000TX
3	Remove expansion rivet (2)
4	Unscrew nuts (3)
5	Unclip cover (4)		Figure
6	Pull filler neck (5) from washer fluid reservoir	replace seal of filler neck (5) on washer fluid reservoir.
7	Pull vent hose (6) off of filler neck (5) and remove filler neck (5)
8	Detach water trough drain hose (7) and put to one side
9	Unscrew nuts (8) and remove air duct (9)
10	Unscrew nut (10)	Replace self-locking nut (10).
11	Remove auxiliary washer fluid reservoir (1) from engine compartment, as far as it takes for the connector hose (12) connection to be accessible
12	Disconnect connector hose (12) on auxiliary washer fluid reservoir (1) and remove auxiliary washer fluid reservoir (1)	Collect washer fluid which flows out. Ensure that the supports (11) are properly seated.
13	Install in the reverse order
14	Fill washer fluid reservoir
	Inspect fluid level of windshield washer system, adjust to correct level		AP82.35-P-8210TX

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA