Pressing out and attaching follower joint at steering knuckle - AR33.20-P-0500-01N
WARNING: This page is about a different car, the 2009 Mercedes-Benz E350 and 2008 Mercedes-Benz E350. However, it is still accessible from the selected car via links, so may be relevant.
MODIFICATION NOTES
| 9.8.08 |
SWZ 140 589 00 33 00 for prying off upper ball joint added |
Step 3 |
WHEEL LOCATION, HUB
| Number |
Designation |
Model 211 except 211.08/09/28/29 |
Model 215 |
| BA33.20-P-1018-01A |
Self-locking nut, upper wishbone follower joint to steering knuckle |
Stage 1 |
Nm |
20 |
20 |
| Stage 2 |
∠° |
90 |
90 |
WHEEL LOCATION, HUB
| Number |
Designation |
Model 230 except code P99 |
Model 230 with code P99 |
| BA33.20-P-1018-01A |
Self-locking nut, upper wishbone follower joint to steering knuckle |
Stage 1 |
Nm |
20 |
50 |
| Stage 2 |
∠° |
90 |
60 |
WHEEL LOCATION, HUB
| Number |
Designation |
Model 220 with Code Z07 |
Model 220 without code Z07 except model 220.08/18/8 |
Model 220.08/18 |
Model 220.875/878 |
| BA33.20-P-1007-01F |
Self-locking nut, upper wishbone follower joint to steering knuckle |
Stage 1 |
Nm |
20 |
20 |
20 |
20 |
| Stage 2 |
∠° |
90 |
90 |
90 |
90 |
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Pushing off
- Unscrew self-locking nut from follower joint (8).
- Screw the thrust washer (043a) onto the support joint (8).
Thrust piece 210 589 04 63 00 (model 211, 215, 220, 230 without code (P99) Special model "AMG Black Series")
Thrust piece 140 589 00 63 00 (model 230 with code (P99) Special model "AMG Black Series")
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
- Press off the follower joint (8)
with the puller (043).
Do not damage rubber boot or stainless steel contact ring otherwise the upper ball joint (8) must be replaced.
Observe variant of upper ball joint (8) (only model 211, 230).
Puller 202 589 02 33 00 (model 211, 215, 220, 230 without code (P99) Special model "AMG Black Series") for upper ball joint without stainless steel contact ring.
Puller 140 589 00 33 00 (model 211, 230 without code (P99) Special model "AMG Black Series") for upper ball joint with stainless steel contact ring.
Puller 221 589 00 33 00 (model 230 with code (P99) Special model "AMG Black Series")
-
Remove puller (043)
and thrust piece (043a).
Attaching
- Clean tapered connection.
There must be no grease or oil on the taper and thread in order to guarantee a faultless connection.
- Replace self-locking nut and screw on
.