Remove SBC bracket (engine installed) - AR62.20-P-1260-09T
WARNING: This page is about a different car, the 2009 Mercedes-Benz E550 and 2008 Mercedes-Benz E550. However, it is still accessible from the selected car via links, so may be relevant.
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1002-01A | Ball cutter, dia. 12 mm |
WORKSHOP EQUIPMENT
| WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
| WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
- Drill rivets on SBC bracket (1) with 6.5 dia. bit. (area A).
- Cut rivet heads out on SBC bracket (1) with spherical cutter
(area B).
- Remove SBC bracket (1)
- Remove rivet residues from longitudinal member with hammer and punch
- Remove grinding and drilling chips using wet/dry vacuum cleaner
Shown on model 211.0