Adjust front module - AR62.30-P-1570-01T
WARNING: This page is about a different car, the 2009 Mercedes-Benz E550 and 2008 Mercedes-Benz E550. However, it is still accessible from the selected car via links, so may be relevant.
MODIFICATION NOTES
| 30.6.04 | Value changed from 70 Nm to 55 | Value modified in BA62.30-P-1001-02A for model 211 | *BA62.30-P-1001-02A |
TEST VALUES FOR GAP DIMENSIONS ON HOODS, DOORS AND LIDS
| Number | Designation | Model 211.0 | Model 211.2 | |||
|---|---|---|---|---|---|---|
| BE60.00-P-1001-01F | Gap dimension | Engine hood to fender | Dimension "A" | mm | 3.5 (±0.5) | 3.5 (±0.5) |
| Engine hood to headlamp | Dimension "B" | mm | 4 (+1) | 4 (±0.5) | ||
| Radiator grille/bumper | Dimension "C" | mm | 5.5 (+1) | 5,5 (±1) | ||
| See picture | AR60.00-P-0700-01T | AR60.00-P-0700-01TA | ||||
FRONT END ASSEMBLY WITH FRONT REINFORCEMENT
| Number | Designation | Model 211 | |
|---|---|---|---|
| BA62.30-P-1001-02A | Bolt connecting front end to longitudinal member | Nm | 55 |
| BA62.30-P-1006-02A | Bolt, outer reinforcement to fender bracket | Nm | 10 |
| BA62.30-P-1007-02A | Bolt, outer reinforcement to side of frame | Nm | 10 |
| BA62.30-P-1008-02A | Bolt, center reinforcement to outer reinforcement | Nm | 10 |
| BA62.30-P-1009-02A | Bolt, center reinforcement to arrester hook reinforcement | Nm | 10 |
| BA62.30-P-1010-02A | Bolt, arrester hook reinforcement to crossmember | Nm | 10 |
| BA62.30-P-1011-02A | Bolt, crossmember to crash box | Nm | 18 |
| BA62.30-P-1012-02A | Bolt, crossmember to combination bracket console | Nm | 10 |
| BA62.30-P-1013-02A | Bolt, side of frame to crossmember | Nm | 10 |
| BA62.30-P-1014-02A | Bolt, outer reinforcement to crash box | Nm | 10 |
- Center front end on longitudinal member and fasten (observe Nm specification).
- Check joints and adjust
engine hood/fender
engine hood/headlamps
radiator grill/bumper
Fine adjustment of the front module is possible only after completing the previously described operations.
- Loosen bolts connecting reinforcement to fender bracket (arrows).
- Loosen screws for front end on longitudinal member.
- After adjustment work, tighten screws to specified torque (Nm)