Cleaner from package - BR00.45-Z-1028-04A

Shown on transmission 722.906 

Fig 1: Identifying Oil Cooling Lines Of Automatic Transmission

Courtesy of MERCEDES-BENZ USA

Shown on transmission 722.906 

Fig 2: Identifying Oil Cooling Lines, Clamps & Screws

Courtesy of MERCEDES-BENZ USA

1. Thoroughly clean area around separation point at hydraulic system.

   Even the smallest dirt particles in the hydraulic components can lead to malfunctions and a total failure of the transmission.

2. Remove bolts (9, 11, 13).
3. Remove double clamps (10, 12, 14) and retaining clamps.
4. Remove bolt (20).
5. Pull right oil cooling line (7) out of transmission and seal line connection and oil hole in transmission using stop plugs.

   To prevent damage and leaks, do not kink or bend the right oil cooling line (7).

   Installation:  Install new gasket

6. Remove bolt (19).
7. Pull left oil cooling line (8) out of transmission and seal line connection and oil hole in transmission using stop plugs.

   To prevent damage and leaks, do not kink or bend the left oil cooling line (8).

   Installation:  Install new gasket

8. Install in the reverse order.