Pull rear axle shaft flange out of angular contact ball bearing - AR35.20-P-0130-06SX

Fig 1: Identifying Press (202 589 04 43 10)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Puller (211 589 01 33 00)

Courtesy of MERCEDES-BENZ USA

1. Position the pressure plate (01) behind the rear axle shaft flange (1).
2. Screw retaining bolts (03) into the rear axle shaft flange (1).
3. Slide the guide plate (05) forwards until the guide pins (02) are fixed in pressure plate (01).
4. Insert press (04) and pull rear axle shaft flange (1) out of angular contact ball bearing (2) by turning the spindle (arrow).
   Fig 3: Pulling Rear Axle Shaft Flange Out Of Angular Contact Ball Bearing By Turning Spindle (Arrow)

   Courtesy of MERCEDES-BENZ USA