LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2010 >> CL550 >> Repair and Diagnosis >> Collision >> General Collision Information >> Rear Wall & Rear End >> Testing & Repair >> Prepare bottom rear center section for installation - AR64.20-P-1000-07SX

Prepare bottom rear center section for installation - AR64.20-P-1000-07SX

Fig 1: Identifying Bottom Rear Center Section (1) Cross-Hatched Areas
G07321181Courtesy of MERCEDES-BENZ USA
  1. Grind mating surfaces on bottom rear center section (1) down to bare metal in cross-hatched areas with COMMERCIALLY AVAILABLE TOOLS round wire brush consisting of stainless steel (areas A, B, C, D, E, F, G, H, I, J, K and L).

    IMPORTANT Observe preliminary treatment of surfaces to be bonded.

  2. Grind mating surfaces on mount below taillamp (2) down to bare metal in cross-hatched areas with COMMERCIALLY AVAILABLE TOOLS round wire brush consisting of stainless steel (areas M, N, O, P, Q, R, S, T, U, V, W, X, Y and Z).

    IMPORTANT Observe preliminary treatment of surfaces to be bonded.

Fig 2: Identifying Grinding Surfaces On Mount Below Taillamp (2) In Cross-Hatched Areas
G07321182Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals