Adjust front door crank window - AR72.10-P-1950SC

MODEL 216.3 

Fig 1: Identifying Front Door Crank Window

Courtesy of MERCEDES-BENZ USA

	Adjust
	Risk of injury caused by moving parts that can pinch, crush or,  in extreme cases even sever  extremities.	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0009-01A
	The power window motor should not be supplied with power directly to prevent damage.
	Use driver power window, outside mirror and trunk lid switch group or front passenger power window switch still installed on the door lining to raise and lower the crank window (1).
1	Check adjustment of left and right front door, correct if necessary.		AR72.10-P-0550SC
2	Remove door foil from front door		AR72.10-P-1010SC
3	Connect battery charger to maintain on-board power supply voltage.		AR54.10-P-1127SX
	Basic setting adjustment in X direction
4	Perform basic adjustment for crank window (1).		AR72.10-P-1950-06SC
			*BA72.10-P-1017-01Q
	Height Adjustment in Z direction
5	Check height adjustment of crank window (1), adjust if necessary	Adjust height of crank window (1) only if its upper edge runs parallel to the retaining rail on the roof frame seal.	AR72.10-P-1950-05SC
6	Check adjustment for rear side window, correct if necessary.		AR67.30-P-4200SC
7	Install door foil		AR72.10-P-1010SC
8	Install door lining.		AR72.10-P-1000SC
9	Denormalize power window of crank window (1) with STAR DIAGNOSIS	Menu points: Control units Seats and doors Left door control unit or right door control unit Actuations Denormalize power window
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
		STAR DIAGNOSIS diagnostic system
10	Normalize power window (1).
11	Clean crank window (1).	Cleaner	*BR00.45-Z-1007-04A

FRONT DOOR

Number	Designation		Model 216
BA72.10-P-1017-01Q	Mount, crank window to power window	Nm	9

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1007-04A	Cleaner, plastic windows, fabric top 500 ml	A 001 986 38 71