Remove/install longitudinal member paneling - AR88.80-P-6000SC

MODEL 216 

Shown on left side of vehicle 

Fig 1: Identifying Longitudinal Member Paneling Remove/Install Components (Shown On Left Side Of Vehicle)

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	see AS00.00-Z-0010-01A
1	Raise vehicle with lifting platform
2	Remove expansion clip (4) from front fender liner (1)
3	Remove expansion clip (6) from rear fender liner (5).
4	Unscrew underfloor paneling in area of longitudinal member paneling (3).
5	Unscrew nuts (9) and loosen longitudinal member paneling (3) at bottom of longitudinal member.
6	Unclip longitudinal member paneling (3) starting at front fender (2) (arrows).	Installation:  Ensure that clips (8) are seated correctly in grommets (7).	Fig 2
7	Install in the reverse order

Fig 2: Identifying Wedge Tool (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA