Remove/install wheels, rotate if necessary - AP40.10-P-4050CW

MODEL 204, 207 

Left illustration 

Fig 1: Identifying Wheel Bolts Tightening Sequence

Courtesy of MERCEDES-BENZ USA

Right figure 

Fig 2: Overview Of Wheel Rotation

Courtesy of MERCEDES-BENZ USA

	Removing
	caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Hoist vehicle with lifting platform until wheels are free
2	Pull off wheel covers	Vehicles with wheel covers
3	Unscrew wheel bolts and remove wheel-and-tire assemblies	Model 204.9: Use wheel lift. Wheel lift. wheel lift truck gotis://F 40.1 06.0	*199589010900
	Checking
4	Check tires for damage and condition, measure tread depth and note down measurements on maintenance sheet		AP40.10-P-4051CW
	Information on tires/rims		AH40.10-P-9411-01A
5	Clean and check wheel bolt connection components, then protect against corrosion	Before mounting a wheel-and-tire assembly all  the operation steps listed in the linked description must be conducted carefully. Otherwise the wheel-and-tire assembly may work its way loose from the vehicle and cause damage to people, property or the environment!	AP40.10-P-4050-01A
	Install
6	Change round wheel-and-tire assemblies on front and rear axles	As required, and only on vehicles without mixed tires Maintain running direction of wheel-and-tire assemblies. Otherwise handling characteristics and handling comfort may be impaired and tire wear increased.
7	Mount wheel-and-tire assembly and tighten wheel bolts	Model 204.9: Use wheel lift. Observe the tightening sequence (1 to 5) and tightening torque. Wheel bolt	-
		Spare tire wheel bolt	-
8	Lower vehicle
9	Correct tire pressure for all wheel-and-tire assemblies	In the event of tire pressure loss, establish cause and replace valve, tire or rim: Replace tire: Model 207	AR40.10-P-1030CW
		Model 204	AR40.10-P-1030EW
		Tire inflation devices - mobile - with/without reservoir gotis://F_40.1_09.2
10	Fit wheel covers	Vehicles with wheel covers
11.1	Activate the tire pressure monitoring system	Only for wheel rotation, tire replacement or change in tire pressure and only vehicles with code (470) Tire pressure monitor (base) or code (475) Tire pressure monitor (Schrader): Restart tire pressure monitor: Model 204	AR54.30-P-1000-02RAD
		Model 207	AR54.30-P-1000-02RAU
11.2	Activate tire pressure loss warner	Only for wheel rotation, tire replacement or change in tire pressure and only vehicles without code (470) Tire pressure monitor (basic) and without code (475) Tire pressure monitor (Schrader): Restart tire pressure loss warning: Model 204	AR54.30-P-1000-02RAC
		Model 207	AR54.30-P-1000-02RAE

Wheels 

Fig 3: Identifying Wheel Hub

Courtesy of MERCEDES-BENZ USA

Repair materials