LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2010 >> C63 >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Axle -- C63/C350 (204) >> Testing & Repair >> Remove/install rear rubber bushings for differential mount in rear axle carrier - AR35.10-P-0050CW

Remove/install rear rubber bushings for differential mount in rear axle carrier - AR35.10-P-0050CW

MODEL 204, 207 

Fig 1: Identifying Rubber Plug, Bolts, Rear Axle Carrier, Screw, Rubber Bushing And Differential
G07532564Courtesy of MERCEDES-BENZ USA
Fig 2: Identifying Bolts, Rear Axle Carrier, Tensioning Strap, Rubber Bushing And Differential
G07532565Courtesy of MERCEDES-BENZ USA
REMOVING Remove    
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. AS00.00-Z-0010-01A
NOTES Notes on self-locking nuts and bolts   AH00.00-N-0001-01A
    NOTES While working on the rear axle care must be taken to ensure that the surfaces of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the of the parts will be reduced.  
1 Shift the transmission into position "N" or into idle position    
2 Switch off ignition    
3 Secure vehicle on the lifting platform   AR00.60-P-0100CW
4 Remove left and right rear diagonal strut Model 207.4  
    TORQUE SPECIFICATION *BA61.10-P-1007-01H 
    TORQUE SPECIFICATION *BA61.10-P-1008-01H 
    TORQUE SPECIFICATION *BA61.10-P-1009-01H 
5 Detach exhaust system at connecting point of catalytic converter/center muffler and remove Vehicles with gasoline engine AR49.10-P-7100CW
    Vehicles with diesel engine AR49.10-P-7100CWI
6 Detach propeller shaft from differential (50)   AR41.10-P-0050CW
7 Lash down differential (50) on rear axle carrier (4) using tensioning strap (6)    
8 Remove struts Model 204.9 AR35.10-P-0042-01CWG
    TORQUE SPECIFICATION *BA35.10-P-1007-01N 
    TORQUE SPECIFICATION *BA35.10-P-1008-01N 
9 Open luggage compartment, remove spare tire if necessary and remove rubber plug (2) from spare wheel recess    
10 Remove left and right bolt (3) of rear differential mount TORQUE SPECIFICATION *BA35.10-P-1006-01N 
11 Support differential (50) with transmission jack and transmission plate    
12 Remove bolt (5) of front differential mount TORQUE SPECIFICATION *BA35.10-P-1005-01N 
13 Lower differential (50)    
14 Press rubber bushing (10) of rear axle differential (50) out of rear axle carrier (4)   AR35.10-P-0050-02CW 
    SPECIAL TOOL Fig 3
    SPECIAL TOOL Fig 4
    SPECIAL TOOL Fig 5
    SPECIAL TOOL Fig 6
    SPECIAL TOOL Fig 7
15 Install in the reverse order    
REAR AXLE CARRIER

Number Designation   Model 204
BA35.10-P-1007-01N Nut, strut to body Nm 25
BA35.10-P-1008-01N Bolt, strut to rear rubber mount of rear axle carrier Nm 25
REAR AXLE CARRIER

Number Designation   Model 204
BA35.10-P-1005-01N Differential to front adapter Nm 65
BA35.10-P-1006-01N Bolt, rear axle differential to rear crossmember Nm 170
FRAME FLOOR ASSEMBLY

Number Designation   Model 207.4
BA61.10-P-1007-01H Bolt, rear diagonal strut on spare wheel well Nm 80
BA61.10-P-1008-01H Bolt, rear diagonal strut on longitudinal member Nm 80
BA61.10-P-1009-01H Bolt, rear diagonal strut to bracket Nm 17
Fig 3: Identifying Extraction And Insertion Tool (221 589 01 43 00)
G07514718Courtesy of MERCEDES-BENZ USA
Fig 4: Identifying Hollow Piston Cylinder (001 589 51 33 00)
G07514719Courtesy of MERCEDES-BENZ USA
Fig 5: Identifying Hand Pump (652 589 00 33 21)
G07514706Courtesy of MERCEDES-BENZ USA
Fig 6: Identifying Hydraulic Hose (Complete) (652 589 00 33 23)
G07514708Courtesy of MERCEDES-BENZ USA
Fig 7: Identifying Extraction And Insertion Tool (204 589 01 43 00)
G07532570Courtesy of MERCEDES-BENZ USA