Remove/install additional battery - AR54.10-P-0007CW

MODEL 204.0/2/3 with CODE (B03) ECO start/stop function 

Shown on model 204.0 

Fig 1: Identifying Additional Battery Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic burns  caused by swallowing battery acid. Risk of injury  caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries	No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
	Notes on battery		AH54.10-P-0001-01A
	Notes on AGM battery		AH54.10-P-0002-01A
1	Switch off all electrical consumers, switch off ignition and remove transmitter key (A8/1) from electronic ignition lock control unit (N73)	All the electrical consumers must be switched off, otherwise they may be damaged when unclipping and clipping on the ground line (5).
2.1	Open luggage compartment floor cover (1)	On model 204.0/3
2.2	Remove rear load compartment floor and intermediate bottom	On model 204.2	AR68.80-P-5800CX
3.1	Unclip expansion clip (3) and remove covering from additional battery (2)	On model 204.0/3 Clip remover	Fig 2
3.2	Detach spare wheel well trim far enough until the additional battery for the ECO start/stop function (G1/13) is accessible	On model 204.2
4	Remove bolt (4) and detach ground line (5) from additional battery for ECO start/stop function (G1/13)		*BA54.10-P-1004-01F
5	Remove cover (6) from positive line (7)
6	Using diode test lamp, check on-board electrical system for voltage between positive line (7) of ECO start/stop function additional battery (G1/13) and a suitable ground point	If the diode test lamp lights up, the on-board electrical system is still active because of a defect in the electrical system. In this case the ground line of the on-board electrical system battery (G1) should be disconnected. See: ↓ Disconnect/connect battery ground line Cover positive line (7), there is a risk of short circuit! If there are faults in the on-board electrical system then they have to be rectified first.	AR54.10-P-0003CW
7	Unscrew bolt (8) and remove positive line (7)		*BA54.10-P-1004-01F
8	Unscrew nut (10) of bracket (11)
9	Swivel bracket (11) upwards
10	Remove additional battery for ECO start/stop function (G1/13) from battery holder
11	Install in the reverse order

Fig 2: Identifying Snap-Release Tool (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA