Remove/install overhead control panel control unit - AR82.20-P-1000CW
MODEL 204, 207, 212, 218
Shown on model 204.0
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Perform initial startup of overhead control panel control unit (N70) or overhead control panel electronics (N70/3) with Star Diagnosis | When replacing overhead control panel control unit (N70) with code (414) Power glass tilting/sliding roof or with code (965) Electrical preinstallation for rental vehicles. |
AD00.00-P-2000-04A |
| 2 | Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit | ||
| 3.1 | Unclip mirror base cover (1) | Model 204, 207.3, 212, 218 |
Fig 2 |
| 3.2 | Unclip rain sensor cover | Model 207.4 without code (513) Speed Limit Assist or code (608) Automatic high beam recognition | |
| 3.3 | Slide cover for rain sensor to the foremost position and remove downwards | Model 207.4 with code (513) Speed Limit Assist or code (608) Automatic high beam recognition | |
| 4 | Use a check card (2) or similar object to release the lock (3) and fold down overhead control panel control unit (N70) or electronic overhead control panel (N70/3) at rear and unhook at front (arrows) | ||
| 5 | Detach all electrical connectors on the overhead control panel control unit (N70) or electronic overhead control panel (N70/3) | ||
| 6 | Install in the reverse order | ||
| 7 | Normalize tilting/sliding roof | When replacing overhead control panel control unit (N70) with code (414) Power glass titling/sliding roof. |