Remove/install headlamp range adjustment front axle sensor - AR82.10-P-4083CW
MODEL 204.0 /2 with CODE (614) Bi-xenon headlamp unit with CODE (615) Bi-xenon headlamp unit with CODE (616) Bi-xenon headlamp unit with integrated asymmetric curve illumination with CODE (618) Bi-xenon headlamps with CODE (621) Intelligent Light System (left-hand traffic) with CODE (622) Intelligent Light System (right-hand traffic) MODEL 204.9 with CODE (614) Bi-xenon headlamp unit with CODE (615) Bi-xenon headlamp unit with CODE (616) Bi-xenon headlamp unit with integrated asymmetric curve illumination with CODE (621) Intelligent Light System (left-hand traffic) with CODE (622) Intelligent Light System (right-hand traffic)
MODEL 207 with CODE (615) Bi-xenon headlamp unit with integrated curve illumination with CODE (616) Bi-xenon headlamp unit with integrated asymmetric curve illumination with CODE (621) Intelligent Light System (left-hand traffic) with CODE (622) Intelligent Light System (right-hand traffic)
MODEL 212 with CODE (615) Bi-xenon headlamp unit with integrated curve illumination with CODE (616) Bi-xenon headlamp unit with integrated asymmetric curve illumination with CODE (621) Intelligent Light System (left-hand traffic) with CODE (622) Intelligent Light System (right-hand traffic) MODEL 218 with CODE (614) Bi-xenon headlamp unit with CODE (615) Bi-xenon headlamp unit with CODE (618) Bi-xenon headlamps with CODE (621) Intelligent Light System (left-hand traffic) with CODE (622) Intelligent Light System (right-hand traffic)
Model 204, model 207, shown on model 204.0 with fender liner removed
Model 212, model 218, shown on model 212
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Lift vehicle on lifting platform. | ||
| 2 | Push left fender liner front section to side in vicinity of left front level sensor (B22/8) | Model 204.9 | |
| 3 | Unclip electrical wiring harness from bracket (3) | ||
| 4 | Disconnect electrical connector from left front level sensor (B22/8). | ||
| 5.1 | Unclip lever (1) at torsion bar | Model 204.0/2, 207 | |
| 5.2 | Unclip lever (1) at strut rod | Model 204.9 | |
| 5.3 | Unclip mounting clip (4) on lever (1) of cross strut (5) | Model 212, 218 | |
| 6 | Unscrew nuts (2) | ||
| 7 | Remove bracket (3) with left front level sensor (B22/8) | ||
| 8 | Detach lever (1) from old left front level sensor (B22/8) and install at new left front level sensor (B22/8) | Model 204.9, when replacing left front level sensor (B22/8). | |
| 9 | Install in the reverse order | ||
| 10 | Connect Star Diagnosis, read out fault memory and adjust zero position of headlamps | AD00.00-P-2000-04A | |
| 11 | Check headlamp setting and correct if necessary | Model 204 | AP82.10-P-8260CW |
| Model 207, 212, 218 | AP82.10-P-8260EW |