Remove/install fog lamp - AR82.10-P-5103CW
MODEL 204.0 /2 /9
MODEL 207
MODEL 212 (except 212.077 /277)
Shown on model 204.0 at right side of vehicle
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | ||
| 2 | Remove engine compartment paneling at front | Model 204.0/2 with removal of left front fog lamp (E5/1). | |
| 3 | Remove front engine compartment paneling | Model 204.9 when removing left front fog lamp (E5/1). | AR61.20-P-1105CY |
| 4 | Detach left fender liner in area of bumper far enough and pry out using assembly wedge until the left front fog lamp (E5/1) can be removed | Model 204.0/2, model 207, model 212, when removing left front fog lamp (E5/1). |
Fig 2 |
| 5 | Detach right fender liner in area of bumper far enough and pry out using assembly wedge until the right front fog lamp (E5/2) can be removed | When removing the right front fog lamp (E5/2). |
Fig 2 |
| 6 | Disconnect electrical connector (2) | ||
| 7 | Remove screws/bolts (1) and remove left front fog lamp (E5/1) or right front fog lamp (E5/2) from bumper | ||
| 8 | Install in the reverse order | ||
| 9 | Check adjustment of left front fog lamp (E5/1) and right front fog lamp (E5/2), correct if necessary. | Model 204 | AP82.10-P-8260CW |
| Model 207, 212 | AP82.10-P-8260EW |