Retrofit rear entertainment wiring harness - AZ82.60-P-0015-02CXA
Routing diagram
Courtesy of MERCEDES-BENZ USA
Connection scheme
Courtesy of MERCEDES-BENZ USA
Make sure that the wiring harnesses are not damaged by chafing, pinching or crushing, as otherwise the corresponding wiring harness may have to be replaced.
The following operation steps are shown on the right side of the vehicle and can be accomplished analogously on the left side of the vehicle.
- Route wiring harness (6) from previously created opening in backrest to video control unit (1).
The video control unit (1) is only placed in the seat and is fastened at a later point.
- Connect wiring harness (6) to video control unit (1).
The white 12-pin coupling (23) is connected at a later point. The connections at video control unit (1) are coded and cannot be swapped.
- Fasten wiring harness (6) at seat frame using cable ties.
- Strap down excess length of line from wiring harness (6).
Courtesy of MERCEDES-BENZ USA
- Route wiring harness (9) from video control unit (1) to front passenger seat connector block.
The video control unit (1) is only placed in the seat and is fastened at a later point.
- Connect wiring harness (9) to video control unit (1).
- Fasten wiring harness (9) at seat frame using cable ties.
Take care that the adjustment mechanism of the seat is not impaired by the installation of lines, as this may lead to shearing or crushing of the wiring harness (9).
Courtesy of MERCEDES-BENZ USA
- Loosen and disconnect front passenger seat connector block (X55/4).
- Connect black 2-pin coupling (24) and black 2-pin connector (25) of wiring harness (9) to disconnected front passenger seat connector block (X55/4).
The black 2-pin coupling (24) and the black 2-pin connector (25) are coded and cannot be swapped.
Courtesy of MERCEDES-BENZ USA
- Connect assembled connectors and fuse carrier at the carrier (33).
The fuse rating is 5 A.
- Fix wiring harness in place with cable ties.
Courtesy of MERCEDES-BENZ USA