Retrofit rear entertainment wiring harness - AZ82.60-P-0015-02CW

Routing diagram 

Fig 1: Identifying Retrofit Rear Entertainment Wiring Harness - Routing Diagram

Courtesy of MERCEDES-BENZ USA

Connection scheme 

Fig 2: Identifying Retrofit Rear Entertainment Wiring Harness - Connection Scheme

Courtesy of MERCEDES-BENZ USA

Ensure that the wiring harnesses are not damaged by chafing or being trapped otherwise the appropriate wiring harness must be replaced.

1. Route wiring harness (6) from previously created opening in backrest to video control unit (1).

   The video control unit (1) is only placed in the seat and is installed at a later point.

2. Connect wiring harness (6) to video control unit (1).

   The white 12-pin coupling (23) is connected at a later point. The connections at video control unit (1) are coded and cannot be swapped.

3. Fasten wiring harness (6) at seat frame using cable ties.
4. Strap down excess length of line from wiring harness (6) using cable ties.
   Fig 3: Identifying 12-Pin Coupling, Wiring Harness And Video Control Unit

   Courtesy of MERCEDES-BENZ USA
5. Route wiring harness (9) from control unit (2) to driver seat control unit (N32/1).

   The control unit (2) is only placed in the seat and is installed at a later point.

6. Connect wiring harness (9) to control unit (2) and to video control unit (1).
7. Fasten wiring harness (9) at seat frame using cable ties.
   Fig 4: Identifying Connection Of Wiring Harness To Control Unit And To Video Control Unit

   Courtesy of MERCEDES-BENZ USA
8. Detach black 4-pin coupling (10) of vehicle wiring harness from driver seat control unit (N32/1) and connect with black 4-pin connector (24) of wiring harness (9).
9. Attach black 4-pin coupling of wiring harness (9) at left front seat control unit (N32/1) at outer left slot.
10. Fasten wiring harness (9) at seat frame using cable ties.
    Fig 5: Identifying 4-Pin Coupling, Connector And Driver Seat Control

    Courtesy of MERCEDES-BENZ USA
11. Connect wiring harness (7) to video control unit (1) and route to previously created opening in backrest on passenger side.

    To ensure a seat adjustment in the longitudinal direction, the wiring harness (7) below the seat must be routed with a loop. Wiring harness (7) is routed below floor coverings. When routing, lift the center console and tilt the seats.

12. Connect wiring harness (7) with right screen wiring harness (8) and fasten right screen wiring harness (8) with cable ties.
    Fig 6: Identifying Wiring Harness And Video Control Unit

    Courtesy of MERCEDES-BENZ USA