Make cutout for bracket - AZ82.60-P-0015-07CWA

The following operation steps are shown on the right side of the vehicle and can be accomplished analogously on the left side of the vehicle.

1. Cut out cutting template (11) along broken line.

   The cutting template (11) is included in the installation kit.

   Fig 1: Identifying Installation Kit Cutting Template

   Courtesy of MERCEDES-BENZ USA
2. Apply cutting template (11) to head restraint and mark separating point (broken line).
3. Remove cutting template (11).
   Fig 2: Applying Cutting Template To Head Restraint

   Courtesy of MERCEDES-BENZ USA
4. Cut seat cover using a knife and fix shackle (12) in place using adhesive tape (13).

   Be very careful while cutting, otherwise the seat cover may be damaged.

5. Work out and remove foam core.

   Be very careful while cutting, otherwise the seat cover may be damaged.

6. Work out seat core until cross strut (14) of seat is accessible.

   Be very careful while cutting, otherwise the seat cover may be damaged.

7. Fold shackle (12) into opening.
   Fig 3: Identifying Shackle, Cross Strut And Adhesive Tape

   Courtesy of MERCEDES-BENZ USA